Having over 10 years of experience in the mechanical processing industry + international logistics, delivering on time
Get In Touch
FREE express international delivery + EASY returns
Search
en
NEWS
NEWS
NEWS

Standard for judging the quality of sheet metal processing chassis and cabinets

January 25th at 3:04pm

1. Check the thickness of the steel plate. You only need to lightly tap with your fingers to know the thickness of the steel plate. The brackets inside the cabinet should also be thicker because sometimes the equipment inside is heavier. If it is too thin, it will not be able to withstand the equipment. Weight gain.

Standard for judging the quality of sheet metal processing chassis and cabinets.

2. Check the surface of the chassis and cabinet for sheet metal processing and painting. A good chassis and cabinet require all steel to be painted and evenly sprayed to achieve good rust and dust prevention effects.

3. Look at the glass. The glass should be thicker. Pay special attention to see if there are any cracks around the glass.

The accessories inside the chassis and cabinet are also very important. If the cabinet has a cable management module that allows cables to be directly fixed on the vertical installation track, it would be huge. In either case, there should be sufficient fixing rings (protecting cables) on the upper and side walls inside the cabinet, and the bottom plate of the cabinet can also be lifted to facilitate wiring below. There are also some screws, nuts, etc. For fixing the rack, this should also be sufficient. This can avoid the trouble caused by insufficient accessories during future expansion.